Home / Coffee knowledge / Profitec Pro 600 Review and Experiences
    Dualboiler
    Profitec Pro 600 Test und Erfahrungen

    Profitec Pro 600 Review and Experiences

    The Profitec Pro 600 is an interesting dual boiler espresso machine from the manufacturer in Baden-Württemberg, Germany. With two PID-controlled boilers for steam and brewing water, two pressure gauges, and a vibration pump, the Profitec Pro 600 is one of the more affordable dual boiler espresso machines. The stainless steel boilers have a volume of 1 liter for steam and 0.75 liters for brewing water. The steam boiler can be switched off, which significantly reduces power consumption.

    The Profitec Pro 600 is equipped with a Faema E61 brewing group and consequently accommodates portafilters with a diameter of 58 mm. This also makes the machine compatible with standard sieves and tampers.

    In addition to the Profitec Pro 600, many other dual boilers are on our test list.

    Test video for the Profitec Pro 600

    Warm-up time until the first espresso

    After just a few minutes, the machine indicates that the boiler has reached the target temperature. However, this does not correspond to the actual brewing temperature present at that time. We measured temperature curves after 10 and 15 minutes and were still far from the target temperature even after a purge shot to warm up the portafilter.

    No surprise! Espresso machines with Faema E61 brewing groups usually need 25 minutes to truly reach the target temperature. This is also the case with the Profitec Pro 600.

    Espresso after 5 or 10 minutes Profitec

    After 25 minutes, the Profitec Pro 600 reaches the target temperature with a purge shot. The espresso machine is then also constant and precise during extraction. This is a pleasure.

    Temperature after 25 minutes

    When checking the Profitec Pro 600 with the WBC protocol, we found that the Profitec with a high frequency of 35 seconds between shots is by no means overtaxed. In fact, the espresso machine tends to overheat. The protocol makes it clear that the machine is very consistent once it reaches its target temperature after a longer running time. Then it is very precise and cannot be thrown off even if the frequency of shots is increased somewhat.

    Copy of Copy of Particle distribution measurement 3

    The following curve shows the power consumption of the Profitec Pro 600 over 25 minutes.

    Power measurement Profitec Pro 600

    This article and text will be supplemented further. The second part of the video and a further report according to the standard of our new test protocol will follow.

    What are your experiences? What do we need to pay attention to? What do you like and what don't you like? Feel free to write it in the comments so we can also test the corresponding experiences with our unit.

    Thank you in advance,

    Michel and Benjamin

    What do you think?

      Which machine should we test next?

      Espresso machine or grinder: Tell us what should be next on our test bench. We read every request.

      We only use your email to follow up on your request. You'll only receive the newsletter if you check the box and confirm. Privacy Policy